How to install impact crusher?
Source:www.smallcrusher.cn Author:GreatWall Views:
In view of the advantages of impact crusher,it is widely used for stone crushing. Upon receipt of the stone crusher, in addition to carefully check if the equipment is intact after transport, it also needs carefully read the installation instructions and precautions equipment, due to the installation is an important prerequisite to ensure the good functioning of the crusher. To facilitate the users to install and use, the following summarizes the main points of impact crusher installation.
How to install impact crusher?
1.Installation personnel should understand impact crusher structure, performance,technical requirements and determine the appropriate installation process to device based on their specific circumstances.
2.At the installation site there is lifting equipment with sufficient lifting capacity. Carefully checking the reserved space and equipment foundation bolt holes for the coordinates of the location is necessary to conform to the provisions of relevant basic design data and equipment total figure. Longitudinal equipment, horizontal base coordinate (vertical and horizontal curves) are the rotor axis centerline and equipment, all reserved space and bolt holes for the center differential can not be greater than ± 10mm.
3.It should be filled with absorbing vibration material between the device and the base to prevent the device a solid foundation after officially put into operation, affecting the progress of works.
4 When installing the body, machine surface must be straight, body and base of intersecting surfaces not leak ash,and anchor bolts should be tightened again. The lower part of the foundation should have enough space to install transport equipment and equipment maintenance.
5.After the installation of impact crusher motor is ready, it should be equipped with the belt guard based on the actual situation of the installation.
6.Sometimes,hammer on the rotor has a string moving radial clearance, so after the first use of the new machine, the gap width between frame and the back plate hammer must ensure not less than 20mm, to make sure that the hammer will not collide with the rear rack.
7.The gap between impact board and the board hammer should gradually transfer to small, and Great Wall proposes to adjust the rotation of the rotor revolutions by hand to check for collision. After adjustment nut locking sleeve to prevent the back plate by loosening the nut gradually decreased vibration plate hammer collide.
8.Because of impact crusher discharge port in the lower, mounting height and how to collied with feeding, discharge device should be achieved during the installation process.